English
 |
| Quantity: | |
|---|---|
TW-1L
OSAKADENTAL
901849900
Dental Ultrasonic Scaler Torque Wrench
Equipped with a clutch mechanism, the torque wrench ensures the efficient protection of the ultrasonic scaler handpiece. When the strength exerted on the scaler tip reaches its limit, the clutch inside the torque wrench engages, causing it to skid.
Scaler tip torque wrench General introduction:
The torque is preset . Once the strength exerted to the scaler tip reaches the limit , the clutch inside the wrench would skid ,could not exert any further strength to the tip, thus effectively protecting the ultrasonic scaler hand piece.
2. The removed tip would be clamped by the wrench , thus not to fall off. There is a setup like a "snap fastener" in the wrench, a spring could clamp the tip firmly once the tip inserted, but the spring does not prohibit the tip separating from the wrench.. By the way, by mains of traditional wrench, a tip must be fixed by hand, this gesture would be assailed by patients who are exquisite in sanitation, consequentially, the doctor drops into an embarrassing satuation.
3. The wrench is made of heat-resistant plastic, it is autoclavable, 135 degree Celsius, 0.22Mpa, time after time.
4. The wrench looks like a cylinder, the cylinder encloses the tip, and the tip is prevented from hurting the hand effectively. On the other hand, the traditional wrench, doesn't cover the tip.
Dental Ultrasonic Scaler Torque Wrench
Equipped with a clutch mechanism, the torque wrench ensures the efficient protection of the ultrasonic scaler handpiece. When the strength exerted on the scaler tip reaches its limit, the clutch inside the torque wrench engages, causing it to skid.
Scaler tip torque wrench General introduction:
The torque is preset . Once the strength exerted to the scaler tip reaches the limit , the clutch inside the wrench would skid ,could not exert any further strength to the tip, thus effectively protecting the ultrasonic scaler hand piece.
2. The removed tip would be clamped by the wrench , thus not to fall off. There is a setup like a "snap fastener" in the wrench, a spring could clamp the tip firmly once the tip inserted, but the spring does not prohibit the tip separating from the wrench.. By the way, by mains of traditional wrench, a tip must be fixed by hand, this gesture would be assailed by patients who are exquisite in sanitation, consequentially, the doctor drops into an embarrassing satuation.
3. The wrench is made of heat-resistant plastic, it is autoclavable, 135 degree Celsius, 0.22Mpa, time after time.
4. The wrench looks like a cylinder, the cylinder encloses the tip, and the tip is prevented from hurting the hand effectively. On the other hand, the traditional wrench, doesn't cover the tip.
